24V | MEANWELL DRIVER | IP20 | 150W

This Meanwell is highly suitable as a 24V power supply for LED strips and LED modules and other constant voltage applications for indoor use. It can be loaded up to a maximum of 150 watts. Additionally, there is an LED that indicates the status (on/off). The output voltage can be finely adjusted with the potentiometer (+V ADJ). It is recommended to check the output voltage before connecting the 24V from the power supply. The potentiometer should then be used to set the voltage as accurately as possible to 24V. If you do not have this option, make sure you do not touch the potentiometer. The amplifier is enclosed in a metal housing. All sides (except the bottom) must be kept clear due to potential heat dissipation. The bottom can be mounted directly onto a surface, but not on top of it, as it serves as a cooling surface. The amplifier can be mounted at 2 points (from the top, top left and bottom right) with 3mm screws/bolts. Please note: No cables are included. You must connect the 110V/220V cable and 24V cable yourself. How to connect these is described above.

-Input voltage: 85 - 132VAC (110V setting), 170 - 264VAC (230V setting) or 240 - 370VDC (in 230V setting) -Output voltage: 24V DC -Maximum output current: 6.5 A Protection against short circuit, overload, and overvoltage (on the output) The other specifications are clearly described in the datasheet. You can find this under the Downloads tab. -L (Live wire, brown wire) -N (Neutral wire, light blue wire) -Earth (Yellow-green wire, connect this for more safety if possible) -2x -V (This is the GND/ground/minus of the 24V) -2x +V (This is the plus of the 24V)